1. Phillips Screwdriver
2. New Motor(s)
3. Silicone Caulking
4. Utility Knife
5. Wire Tool (works as a cutter and a crimper)
6. 5/16 Ratchet

Remove Filter.

Unscrew wing nut from the bottom of your filter.

Pull down on filter to remove.

Remove Lid & Screws.

1. Locate Lid.
2. Using a Phillips screwdriver, remove the screws from the lid. Rotate screwdriver left to loosen screws.
3. Cut the silicone seal away from the lid. Note: Tote, Model 1 & Model 1A models do not have a silicone seal.
4. Peel back foam.

Locate Ground Wire.

The ground wire is the yellow-green wire.

Cut Ground Wire.

Using your wire cutters, cut the ground wire end closest to the motor.

Unplug Motor Wire #1.

Locate the white wire with the blue wire end.

Gently pull up to unplug the wire

Unplug Motor Wire #2.

Locate the black wire with the brass wire end.

Gently pull up to unplug the wire

Loosen Motor Clamp.

Using your 5/16 ratchet, loosen the motor clamp.

Remove Clamp & Clamp Cardboard.

Remove Clamp.

After the clamp is removed you should notice a little piece of cardboard stuck to the black motor boot. Pull it off and set it aside.

Pop Rubber Boot.

Make sure that you have a hold of the motor from the bottom. Using you finger pop up the rubber boot and the motor will fall through the motor ring.

Remove Old Motor.

Pull the motor down and out to remove.