ClipperVac.com
Information
 Introduction
    About Us
    Testimonials
 Shows & Seminars


Our Products
 Clipper Vac®
    Clipper Attachments
    Rake-N-Vac®
    Snap On Combs
    Accessories
   Educational DVDs
    Replacement Parts
  Force Dryers
   Accessories
   Educational DVD
    Replacement Parts
 Pet VestTM Support System
 Work Styling Stations
 Coin-Op Pet Wash

Distributed Products
Education
PA Academy Of Pet GroomingHave A Question? Ask Marlene!
PA Academy Of Pet GroomingPA Academy of Pet
Grooming Website

Education
Request Information
Mailing List
HELP! Technical Support

We Accept These Forms of Payment
monthy special customer survey clipper vac (r) in action

Andis AGC Attachment - Installation Procedure
Step 1: Unplug The Clipper!
Step 2: Remove the clipper blade.
Step 3: Remove the clipper drive assembly service cap.
Step 4: Remove the two Phillips screws that are holding the drive assembly. Remove ONLY the screws.
Step 5: Using the picture, locate the rear tab on your Andis AGC clipper attachment.
Step 6: Place the Andis AGC attachment on the clipper in the place of the drive assembly cover plate.

Tilt the head toward the back of the clipper and push to insert rear tab into the clipper housing.

After inserting tab, tilt the head forward into place.

Step 7: Install enclosed screws. Do Not Over Tighten!

Make sure that the screw heads are completely touching the clipper attachment.

Step 8: Reinstall the clipper blade.

Let Us Know How Our Installation Procedures Worked For You!

M.D.C. Romani Inc.
2860 West Pike Road
Indiana, PA 15701
Phone: (724) 463-6101
Fax: (724) 349-0237
info@clippervac.com