|
|
| Andis Head - Installation
Procedure |
 |
|
|
|
|
|
|
Step 1: |
|
Unplug The Clipper! |
 |
|
|
|
|
|
|
|
|
|
|
Step 2: |
|
Pull out the clipper blade and gently lift up to remove. |
 |
|
|
|
|
|
|
|
|
|
|
Step 3: |
|
Remove the screws from the bottom of the clipper housing.
Turn screwdriver to the left to unscrew. |
 |
|
|
|
|
|
|
|
|
|
|
Step 4: |
|
Notice that two large screws go in the front and the two smaller
screws go in the back of the clipper. |
 |
|
|
|
|
|
|
|
|
|
|
Step 5: |
|
Gently lift up the top portion of the clipper housing and
remove. Be careful not to disturb
the interior clipper parts. |
 |
|
|
|
|
|
|
|
|
|
|
Step 7: |
|
Gently place you new clipper attachment in place of the top
portion of the clipper housing. Make
sure the cord end is inserted in its correct position.
The clipper attachment should set right into place. |
 |
|
|
|
|
|
|
|
|
|
|
Step 8: |
|
When the new head attachment is is in place your clipper should
look like this. |
 |
|
|
|
|
|
|
|
|
|
|
Step 9: |
|
Replace large screws in the top portion of the clipper and
the small screws in the bottom portion. |
 |
|
|
|
|
|
|
|
|
|
|
Step 10: |
|
When tightening bottom screws. Be sure
not to over tighten. Only tighten until the top and the
bottom portion of the clipper housing are completely flush. |
 |
|
|
|
|
|
|
|
|
|
|
Step 11: |
|
Replace clipper blade and push blade toward clipper to lock
in place. |
 |
|
|
|
Let Us Know How Our Installation Procedures Worked
For You!
|
PA Academy of Pet
