Insert New Motor.

Insert the new motor up through the motor ring.

Note: For Tote models you must insert the motor without the filter connected.

Hold Motor In Place.

Use a book, block, box, etc., to hold the motor high enough so you can fold down the rubber boot.

Fold Rubber Boot.

Using your fingers gently fold the rubber boot over the motor ring.

Install Motor Clamp Cardboard.

Reinstall the Motor Clamp. Make sure the cardboard is inserted between the rubber boot and the clamp. It is very important that this step is correct. The cardboard is to insure that the clamp does not split the rubber boot.

Tighten Clamp.

Using your 5/16 ratchet, tighten the motor clamp.

Be Careful not to over tighten.

Cut Green Ground Wire.

Locate the green ground wire with the blue wire end.

Cut the wire 3 or 4 inches below the blue end.

Strip Unit Ground Wire.

Using your wire strippers, strip the green ground wire still connected to your unit.

Connect Ground Wires.

1. Twist together the green ground wire from your unit with the yellow & green ground wire on your new motor.
2. Insert twisted wires into the yellow wire cap.
3. Turn wire cap until snug
4. Wire cap correctly connected.

Plug In Black Wire With Red End.

Locate the black wire with a red end on your new motor.

Plug it in to the switch.

Strip Black & White Wires.

Locate the other black wire on your new motor.

Locate the white wire you cut earlier.

Strip the wires. The white wire may already be stripped if it was not soldered earlier.

Connect Black & White Wires.

Insert wires into the yellow wire cap.

Turn wire cap until snug.

Move Wires Away From Motor.

Tuck all loose wires into the foam to make sure they do not get into the motor.

Test Run

Make sure to plug in your unit and test run the motor before replacing the lid.

Replace Foam

Gently replace foam to its original position.

Replace Lid & Screws

Replace the lid.

When starting each screw make sure you are screwing into the original holes.

If not, you could strip out each hole and your lid will not seal correctly.